Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 230)

5-12 W A N s u i t e 5 1 6 0 / 5 1 3 0
Cmd Lets you control basic aspects of the BERT performed, including the injection
of errors during test.
Values: Stop, Reset, Error Inject, Start
Default: Stop
Configuration Menu
The Configuration menu lets you configure the parameters of the various
interfaces.
Figure 5.12 WANsuite 5160 Configuration Menu Tree
Figure 5.13 WANsuite 5130 Configuration Menu Tree
TCP/IP Configuration Menu
The TCP/IP CONFIG menu lets you configure the unit’s IP parameters. Use
the
SCROLL button to display the desired configuration parameter, and then
press the SELECT button to activate the configuration function.
Figure 5.14 TCP/IP Configuration Menu Tree
IP Address This menu lets you assign a unique network address to this unit.
To establish an IP Address, press the SELECT button to activate a blinking
cursor over the first digit’s location (an “x”) in the address, indicating the
value is selected for change. Press the
SCROLL button to incrementally
change the selected digit’s value (0–9). When the desired value for a selected
portion of the address is displayed, press the
SELECT button to set that value
TCP/IP Config
Configuration
Net 2 Config Serial 2 Config Net 1 Config Serial 1 Config Supv Config
Configuration
Serial Config Net Config TCP/IP Config
TCP/IP Config
Subnet Mask
xxx.xxx.xxx.xx
IP Address
xxx.xxx.xxx.xx
Gateway Address
xxx.xxx.xxx.xx
DHCP Client
Dis
En
Ethernet
Dis
En