Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 39)

W e b S e r v e r I n t e r f a c e 3-7
Line Build-Out (Long
Haul)
Sets the transmit Line Build Out (LBO) for the Long-Haul network interface.
Values: 0,
−
7.5,
−
15.0,
−
22.5 dB
Default: 0 dB
DSX Level (Short
Haul)
Specifies the DTE DSX-1 interface output level.
Values: 0
−
110, 111
−
220, 221
−
330, 331
−
440, 441
−
550, 551
−
660, >661 ft
Default: 0
−110
ft
Framing Selects the framing for the network side of the DSU/CSU.
Values ESF, D4
Default: ESF
Coding Sets the network side line coding.
Values: AMI, B8ZS
Default: B8ZS
Timing Sets the timing source to synchronize the unit’s internal timing generators. In
all cases, slips are controlled to occur on frame boundaries at the Network
ports when timing synchronization is lost. The options are as follows:
Network 1 (5160)
“Function” parameter (on the Network 2 screen) in “Slaved” mode
−
Internal,
Network 1, Network 2, Serial 1, Serial 2
“Function” parameter (on the Network 2 screen) in Network mode
−
Internal,
Network 1, Serial 1
Network 2 (5160)
“Function” parameter in “Slaved” mode
−
timing parameter is ignored in
Slave mode
“Function” parameter in Network mode
−
Internal, Network 2, Serial 2
Network (5130)
−
Internal, Network, Serial
Definitions of the timing sources are as follows:
Internal – The unit’s internal frequency standard (T1 1.544 Mbps ± 50 bps)
is used for all timing.
Network 1, Network 2, Network – Timing is derived from the Network port
recovered clock.
Serial 1, Serial 2, Serial – Timing is derived from the Serial port recovered
clock.
Zero Suppression Determines whether ones density insertion is activated after 15 zeros. This
parameter is ignored if the Coding parameter is set to “B8ZS.”
Values: Disable, Enable
Default: Disable
PRM Enable Lets you establish which performance messaging standard will be employed
to initiate Performance Report Message (PRM) functions. Setting this field to