Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 239)

F r o n t P a n e l L C D I n t e r f a c e 5-21
For more information on pin assignments, refer to Serial Interface Pin
Assignments, DTE Mode (Packet Use Only) on page A-7 and Serial Interface
Pin Assignments, DCE Mode on page A-9.
DTR Alrm This lets you set the Data Terminal Ready (DTR) alarm control parameters.
Choices for DTR Alarm Control are “Enable” and “Disable.” Setting DTR
Alarm Control to “Enable” allows the unit to go into alarm on a loss of DTR.
Values: Disable, Enable
Default:Disable
Supervisory Configuration Menu
Use the SUPV menu to set up parameter values for the Supervisory port as
shown in Figure 5.18 and defined in the paragraphs below.
Figure 5.18 Supervisory Configuration Menu
Speed Changes the Supervisory port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 19200
Ch Size Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Stop Bits Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
Parity Sets the parity bit if the port is asynchronous.
Values: None, Odd, Even
Default: None
DTR Alarm Sets the DTR Alarm.
Values: Enable, Disable
Default: Disable
Diag Msgs Enables the Supervisory port to send out diagnostic messages upon power-up.
Values: Enable, Disable
Default: Enable
Supv
Config
Speed Parity Stop Bits
1200, 2400,
4800,9600,
19200, 38400,
57600, 115200
None
Odd
Even
1
2
DTR Alarm
Dis
En
Diag Msgs
Dis
En
Five
Six
Seven
Eight
Ch Size