Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 54)

3-22 W A N s u i t e 5 1 6 0 / 5 1 3 0
on screen. The Interface for the newly added service will be “Unassigned.” To
assign an interface for the new service, click on its index number, which will
take you to the Service Details screen described below.
NOTICE: Any changes to settings in the Service Table require a “Save and
Restart” for them to take effect.
Service Details Screen
Clicking on an index number under the “Service Index” column on the
Services screen will display a Service Details screen such as the one shown
below (Figure 3.19). (In this example, the selected service type is Frame
Relay.)
Figure 3.19 Service Details Screen
The Service Details screen lets you change for each service the parameters
listed below.
* PPP is the only service that may be attached to the Virtual interface. You would choose the
Virtual interface for PPP if you elected to run PPP over Frame Relay. When you attach PPP to
the Virtual interface, you must supply an endpoint over which to send PPP encapsulated data,
and that endpoint must be for a Frame Relay DLCI.
Parameter Options
Interface Unassigned, Supervisory, Network 1 or Network 2 (5160), Network
(5130), Serial 1 or Serial 2 (5160), Serial (5130), 10/100 Ethernet,
Virtual*
Type TDM, PPP, Frame Relay, IP, tty, SCADA
Pair User-assigned integer field that specifies where to route the traffic
from this Service. If the Service is terminated by the unit, set this
value to “0” (zero).