Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 232)

5-14 W A N s u i t e 5 1 6 0 / 5 1 3 0
Figure 5.15 Network 1 (5160) or Network (5130) Configuration Menu Tree
The Network 1 or Network interface can have independently selected values
for the following parameters:
Mode Selects the network service type.
Values: Long Haul, Short Haul
Default:Long Haul
LBO Sets the transmit Line Build Out (LBO) for the network interface.
Values: 0,
−
7.5,
−
15.0,
−
22.5 dB
Default:0 dB
Framing Selects the framing for the network side of the DSU/CSU.
Values ESF, D4
Default:ESF
Coding Sets the network side line coding.
Values: AMI, B8ZS
Default:B8ZS
Timing Sets the timing source to synchronize the unit’s internal timing generators. In
all cases, slips are controlled to occur on frame boundaries at the Network
and/or DSX-1 ports when timing synchronization is lost. Choices are as
follows:
Network 1 (5160)
−
Int, Net 1, Net 2, Serial 1, Serial 2
Network 2 (5160)
−
Int, Net 2, Serial 2
Network (5130)
−
Int, Net, Serial
Definitions of the timing sources are as follows:
Internal – The unit’s internal frequency standard (T1 1.544 Mbps ± 50 bps)
is used for all timing.
Net 1
Config
Framing Coding Timing LBO
ESF
D4
B8ZS
AMI
Int
Net 1
Net 2
Serial 1
Serial 2
0
− 7.5
− 15.0
− 22.5
Zero Suppression
Dis
En
PRM
Dis
En
Mode
Long-Haul
Shrt-Haul
Learn DS0 Boot Learn DS0 As Learn DS0 Now