Rip parameters, Ospf parameters, Rip parameters -62 – Verilink WANsuite 5130 (34-00298.L) Product Manual User Manual
Page 94: Ospf parameters -62
3-62
W A N s u i t e 5 1 6 0 / 5 1 3 0
Figure 3.50
IP Gateway Details Screen
RIP Parameters
RIP Enable
Globally enables RIP 1, RIP 2, or No RIP.
Values: Disable, Enable RIP1, Enable RIP2
Default: Enable RIP2
RIP Trust Neighbors
Globally enables the trusted neighbors feature. If there is a list of trusted
neighbors in an IP Gateway, only RIP packets coming from those trusted
neighbors will be used to build the internal routing table.
Values: Enable, Disable
Default: Enable
RIP Interval
Interval for RIP packet to be sent. Default is 30 seconds.
RIP Domain
Value representing the RIP domain. Default is 0.
OSPF Parameters
OSPF Enable
Globally enables OSPF.
Values: Disable, Enable
Default: Disable
OSPF Router ID
This 32-bit number assigned to each router running the OSPF protocol
uniquely identifies the router within an Autonomous System. Each router
requires a unique router ID. Default is the LAN IP address of the unit.