Verilink WANsuite 5130 (34-00298.L) Product Manual - Manual (Page 235)

F r o n t P a n e l L C D I n t e r f a c e 5-17
In Slave mode
−
timing parameter is ignored in Slave mode
In Network mode
−
Internal, Network 2, Serial 2
Definitions of the timing sources are as follows:
Internal – The unit’s internal frequency standard (T1 1.544 Mbps ± 50 bps)
is used for all timing.
Network 2 – Timing is derived from the Network port recovered clock.
Serial 2 – Timing is derived from the Serial port recovered clock.
Zero Suppression Determines whether ones density insertion is activated after 15 zeros. This
parameter is ignored if the Coding parameter is set to “B8ZS”.
Values: Disable, Enable
Default:Disable
PRM Lets you establish which performance messaging standard will be employed
to initiate Performance Report Message (PRM) functions. Setting this field to
“Enable” instructs the unit to use ANSI T1.403, which sends a PRM once
every second. Setting this field to “Disable” instructs the unit to use AT&T
TR54016, which provides performance reporting on request only.
Values: Disable, Enable
Default:Disable
Channel Map Menu The Channel Map menu allows channels to be allocated/unallocated to the
Net 2 interface. The values for this option are as follows:
• Idle
−
Channel not allocated
• Thru
−
Allocated to NET 2
• T+Sig
−
Allocate and Signaling enabled
There is no default value for this option.
Serial 1 and Serial 2 (5160) or Serial (5130) Configuration
Menus
The SERIAL INTERFACE #1 and SERIAL INTERFACE #2 configuration
menus on the WANsuite 5160 and the SERIAL INTERFACE on the
WANsuite 5130 let you view and make changes to the unit’s serial interface
configurations.