Teac MX-View Version 1.0b1 - Manual (Page 9)

9
Chapter 2: Ethernet Setup
Chapter 2 reviews the two basic Ethernet hardware configurations as well as System requirements. Please
refer to the MX-View software release notes for software installation instructions.
2-1 System Requirements
Please refer to the software release notes for system requirements.
2-2 MX-2424/MMR direct to Computer
A computer running MX-View can connect directly to an MX-2424/MMR using one
Category 5 Crossover Ethernet cable. Connect one end of the cable to the Ethernet port
on the recorder and the other end to the computer Ethernet port.
2-3 MX-2424/MMR to Computer via Ethernet Hub
A single or group of MX-2424/MMR machines can be connected to an MX-View
computer via a 100-baseT Fast Ethernet hub. All cables in this configuration must be
standard Category 5 Ethernet “Patch” cables (also referred to as “Straight” cables).
Connect each machine to the hub, including the computer. The Uplink port on the hub
may be used only when connecting that specific hub to another hub.
Note: Most Ethernet cable runs should not exceed 100 meters/328 feet.
Crossover Ethernet Cable
Computer