Teac MX-View Version 1.0b1 - Manual (Page 30)

30
5-4 Loop Play
To perform a Loop Play, you must first set In and Out points as explained in section 4-9.
Click the Loop button in the Transport Window to begin a Loop Play.
Note: Three Loop Modes are available – Play Repeatedly (default), Play Once and Cue, and Play
Once and Stop - which can be set in the MX-2424 Menu 210. For more detail on Loop modes
please refer to MX-2424 Manual Menu Bank 200: System Controls (Page 38 of the Complete MX-
2424 User Manual).
Press any transport key to stop a Loop play.
Q
K Ctrl + L on Microsoft Windows, Cmd + L on Macintosh
5-5 Last Play
A Last Play command initiates a Play command at the location where Play was last
initiated. To perform a Last Play select Playback Menu
→ → → → Last or press the L key.
Loop button: turns bright
yellow when selected.
In Point
In and out points selected,
Loop Mode initiated.
Pre-roll
Post-roll Out Point
{ The playhead locates to
the Pre-roll before the In
point and begins to play
| The playhead plays all the
way to the Post-roll after the
Out point and stops.
} Depending on the loop
mode defined in MX-2424
Menu 210, a loop may
repeat until stopped, relocate
to point 1 and stop or remain
at point 2.
|
{