Teac MX-View Version 1.0b1 - Manual (Page 41)

41
Drag and Trim Tool
The Drag and Trim Tool, located in the Transport Window ( ) can be used to select an
event or group of events and drag them to a new location. To select a single event simply
click on it once. To select a group of events, hold down Shift and click on the desired
events. In and Out points are automatically set and Track Edit buttons automatically
armed when selecting events. To deselect an event, hold down Shift and click on the
selected event, or hold down Ctrl and click on selected event
Additional events can be selected by holding down the Shift button, clicking from an
empty area, and dragging over the desired additional events. Using the same method of
clicking and dragging from an empty area, events can be deselecting while holding down
the Ctrl key.
A group of events can also be selected by clicking on an empty area and dragging across
an event or group of events. Use the Escape key to abort a drag selection.
Track Edit
button armed
Selected audio
region
Note blank areas can
also be selected
In and Out
points
1 Begin drag from
empty area
2 End drag (release
mouse)
Selected audio
region
1
2