Teac MX-View Version 1.0b1 - Manual (Page 29)

29
Chapter 5: Playback, Navigation, and Record
Chapter 5 reviews recording and playback operations, modes, and options. In addition to this, a
comprehensive Navigation section covers locating, zooming, and maneuvering within a project.
Playback Modes and Options
5-1 Play
The transport can be set to play by clicking the play button ( ) in the Transport window
or via the Space Bar quick key. When in play, the playhead will remain stationary at the
center of the screen while audio tracks move horizontally to the left, unless one of the
other Playback options is selected.
Q
K Play or Stop: Space Bar for both Microsoft Windows and Macintosh.
5-2 Pages With Playhead Scrolling
When Pages With Playhead is selected (Playback Menu
→ → → →Pages With Playhead), the
playhead scrolls to the right across the screen when in play. When the right edge of the
screen is reached, the main MX-View window contents are scrolled and the playhead is
moved to the left of the screen to repeat this process again.
5-3 “In to Out“ Play
“In to Out” play sets the transport into play from the In point. After reaching the Out
point, the playhead relocates back to the In point and stops. This is a very convenient
means of auditioning audio. To perform an “In to Out” playback, set In and Out points
(refer to section 4-9) and select Playback Menu
→ → → → In to Out.
Q
K In to Out Play: Shift + Spacebar on both Microsoft Windows and Macintosh
T
iP To include Pre and Post-roll playback for an “In to Out” command, click the Pre and
Post-roll checkboxes in the Transport. “In to Out” play will then begin at the Pre-roll
before the In point and end at the Post-roll following the Out point. More on Pre and
Post-roll settings can be found in section 5-8.
Example: In and Out points are set and “In to Out” is initiated
{ The playhead locates to In point
and initiates a Play.
| After reaching the Out point, the
playhead relocates to the In point
and stops.
Out Point In Point
| {
Pre-roll and
Post-roll
enable/disable