Loudness 1 and loudness 2 menus – Omnia Audio Omnia.9 User Manual
Page 120
R The Volume and Master Gain:FEKIFCJ8I<;LGC@:8K found here as well for convenience. R 4? G8I8D K? K?<:FIE point. R The Delay All control allows you to delay the audio output of the Speaker and Headphone outputs. R The Delay Left and Delay Right controls provide a means by which to delay one channel independently of the other. R The Invert Left and Invert Right controls let you swap the polarity of each channel. The ability to do so in one channel or the other can be useful if you discover that one of the speakers has been wired out of phase and it is not practical or convenient to physically switch the positive and negative wires. Being able to do so to both channels simultaneously can come in handy if you are in a situation where both channels have gotten out of phase at some point in the studio wiring. R The Bass Limiter Threshold controls for the Left and Right channels set the threshold of the bass limiters. Keep in mind that these controls affect only the monitor output audio and have no effect on any of the on-air processing cores, but they are very useful when pushing higher volumes and more bass through very small speakers. R The Limiter Threshold controls for the Left and Right channels set the threshold of the Protection Limiters in each Monitor Output section and operate in the same manner as their counterpart in the %! 8E; FK? :FI monitor output audio is affected. Loudness 1 and Loudness 2 Menus 1?<)FL;E monitor output depending upon the volume level. Chapter 17 Monitor Output Menu 120