beautypg.com

K. changelog, Changelog – Metric Halo Mobile I/O User Manual

Page 352

background image

352

K. Changelog

v5.6.01:

Changes:

• Added

ConsoleSync "On Launch" behaviors

to MIO Console preferences

• Added

ConsoleSync preferences

to MIO Console preferences

• Added ConsoleConnect support for 64 bit VST hosts
• Enabled Retina support for MIO Console
• Updated firmware version to 5.0.44

Bugfixes:

• Fixed a bug where the I/O insert routing was not correctly updated
• Fixed a bug where the I/O insert could not be instantiated on an aux bus
• Fixed a crash where the +DSP noise generator plug-in would stop output if the interface's sample rate

changed

• Fixed a crash when loading factory default mixer for an unknown box type
• Fixed grunge that occurs on some hardware with ConsoleSync
• Protect against a crash when we have a failed instantiation on change of width of mixer strip
• Disable trying to load the DSP Load percentage from an offline box
• Properly track output path settings so that console does not offset the trim on outputs when loading

back from hardware

• Reset Analog I/O configuration and refresh MIO Console window when loading Factory Default state
• Fix corruption of HW gains by Monitor Controller when box state is preloaded from prefs state and then

is loaded back from HW via ConsoleSync

• Ensure that MIO Console respects eLoadLastStateWithoutConsoleSync when the hardware is in the Fac-

tory Default state

• Workaround for failed flash update when hardware sees stuck bits in DRAM
• Fix crash that could occur if no box is selected in MIO Console Window
• Select newly discovered box in MIO Console window if there are were no boxes in the system
• Update compatibility version number of boot-states in firmware

v5.6:

Changes:

• Added

I/O insert

to the Mixer

• Added

ConsoleSync

(console synchronization engine)

• Added

factory default auto-load

for when there is no box state on the computer

• Added

box merging

in the Mixer when a box is added and there is no data for it in the state on the

computer

• Added

“Save System Boot State (all boxes)”

command

• Added “Channel Strip Meters Post Fader” setting to the MIO menu when ConsoleConnect is in plug-

in mode

• Added AAX plugin for ConsoleConnect
• Fixed a bug where plug-in and graph preset names were not tracked properly
• Override Mac OS X autorestore behavior with users preference
• Changed

Enable Legacy Box Support

preference to be off by default