Metric Halo Mobile I/O - Manual (Page 202)

Routing Examples
202
With the 2d Card, we can add reverb “In the Box”. You can still connect outboard gear to add other effects
if desired.
The first thing we need to do is configure our mixers and routing. For this setup we will use two mix busses in
MIO Console: one for the actual headphone mix and one for the send mix to the reverb. To do this we need
to bring up the Mixer Config sheet for the v.5 mixer:
Figure 13.2: Mix Config Sheet
Add two busses to the mixer by clicking the + button in the Mix Busses section twice. Double click the first
bus to name it, and tab to name the second bus. Also, set the Reverb bus’s Bus Mode to Aux Bus: