Metric Halo Mobile I/O - Manual (Page 275)

+DSP
275
Side Invert
{Off, On}
When enabled, inverts the 2nd input channel before processing.
Mode
{Decode (Constant Amplitude), Decode (Constant Power), Encode (Constant Amplitude), En-
code (Constant Power), LR->MS->LR}
Selects the processing mode.
Decode (Constant Amplitude)
Makes input 1 be the Mid Channel and input 2 the Side Channel. In this mode, the processor
decodes the M/S input to Left and Right outputs, keeping the total amplitude constant. The
center point is output compensated to not clip.
Decode (Constant Power)
Makes input 1 be the Mid Channel and input 2 the Side Channel. In this mode, the processor
decodes the M/S input to Left and Right outputs, keeping the total power constant (the ampli-
tude increases, and may go over 1). It is possible to clip audio using this setting.
Encode (Constant Amplitude)
Makes input 1 be the Left Channel and input 2 the Right Channel. In this mode, the processor
encodes the Left and Right inputs to M/S outputs, keeping the total amplitude constant. The
center point is output compensated to not clip.
Encode (Constant Power)
Makes input 1 be the Left Channel and input 2 the Right Channel. In this mode, the proces-
sor encodes the Left and Right inputs to M/S outputs, keeping the total power constant (the
amplitude increases, and may go over 1). It is possible to clip audio using this setting.
LR->MS->LR
Makes input 1 be the Left Channel and input 2 the Right Channel. In this mode, the processor
encodes the Left and Right inputs to an internal M/S representation,applies the width and
rotation transformations in the M/S representation and then decodes the transformed M/S
channels back to Left and Right outputs.
Width
[0, 1]
Adjusts the width of the transformed field. When this parameter is 0, the ouput will be mono.
When this is 1, the full stereo width is represented.
Rotation
[-180, 180] °
Rotates the stereo field by the specified angle.
Master Bypass
{On, Off}
Bypasses all of the processing.
MIO M/S Decoder
• Synopsis: Mid/Side Decoder
• Category: Spatial, Building Blocks
• Channels: 2
Description:
M/S Decoder is a Mid/Side Decoder. It can be used to decode material that was previously encoded
as Mid/Side.
Parameters:
Mid Invert
{Off, On}
When enabled, inverts the 1st input channel before processing.