Other preferences, Channel strip meters post fader preference – Metric Halo Mobile I/O User Manual
Page 255
MIO Console Preferences
255
Check for unregistered units — When checked, MIO Console will connect to the registration server (if
the computer is online) and prompt you to register your interface if it is not registered. Please see the
section on
for more information.
Other Preferences
There are specific preferences in three other locations in MIO Console:
• The box specific preferences, available by clicking on the serial number of the interface in the I/O tab.
These are detailed in the
section of the MIO Console Overview.
• The Record Panel preferences, available in the Recording menu or the Prefs button in the Recording
pane. These are detailed in the
section of the Record Panel chapter.
• The Channel Strip Meters Post Fader setting, available in the Mixer menu. The default is Post Fader,
meaning that the channel faders show the signal level after the fader. To show the Pre Fader level,
uncheck this setting.
Figure 17.4: Channel Strip Meters Post Fader Preference
• More information on the Control Surface preferences is available in the
Control Surface Support chapter
.