Measurement Computing eZ-TOMAS rev.11.0 - Manual (Page 40)

Limits
The Limits Configuration window is accessed from the Edit pull-down
menu. The window provides the user with a means of setting limits and
ranges via three main scenarios. These involve setting:
Default Spectral Limits [without RPM ranges]
(used for Acquisitions, or in Post Acquisition for reports)
•
•
•
RPM Alarm Ranges and RPM Alarm Limits
(used for Acquisitions, or in Post Acquisition for reports)
Selecting Limits from the Edit
Pull-down Menu
Excel Report Ranges and Delayed Limits
( Only used in Post Acquisition for reports)
The type of configuration is determined by radio button selection, as can be seen in the following pages.
Up to two High (HI and HI-HI) and two Low (LO and LO-LO) limits can be defined for each channel’s
operating condition. The graph colors are defined in the Display Preferences window. If the channel
value is lower than the LO-LO limit, the bar graph will change to the color indicated in the LO-LO column
header (see following figure). A value between LO-LO and LO limits will cause the bar graph color to
change to the specified LO limit color. HI and HI-HI limits have the same effect, relative to channel value.
A bar will be green for normal channel values (those between the LO and Hi limits.
Partial Spectral Limits Panel Showing
User-set Color Indications for LO-LO, LO, HI, and HI-HI
Example of Limits Effects on the Gage Panel’s Color Bars
4-12 Edit Menu 947394 eZ-TOMAS