Measurement Computing eZ-TOMAS rev.11.0 User Manual
Page 14
When eZ-TOMAS is being used by multiple computers, a network xfer graphic appears, as indicated in the
follow figure. Networking is discussed in Chapter 9.
Options Panel with the Network Xfer Icon
The Options Panel includes a
resets the peak values. However, the new peak acquisition values [which exist after the point of reset] will
immediately apply.
Clicking the
to select a jpeg or bitmap image to represent the machine, for example, a picture of an engine or turbine. A
text field is present, which is convenient for entering a machine identifier, such as a serial number or a
factory reference label (see figure at right).
To change the title bar of the machine graphic, pull down the Gauge Window’s” Edit menu, select “Display
Preferences,” then type the desired entry into the Machine Information panel’s “Name” field.
In regard to the graphic image, if you right-click in the window, two choices will appear: “Load graphic
picture” and “Remove Graphic Picture.” Clicking on the former allow you to browse your PC for the
appropriate graphic. Note that this can also be accomplished through the Edit pull-down menu.
Machine Graphic Picture
1-10 Introduction
889895
eZ-TOMAS