LSC Lighting CLARITY LX Series v.1 - Manual (Page 276)

Compliance Statements Clarity
Operator Manual
Page 266
46 COMPLIANCE STATEMENTS
Declaration of Conformity
This is to certify that the LX, QX and VX products are approved for use in Europe and
Australia/New Zealand and conform to the following standards:
European Norms Australian / New Zealand Standards
EN55103-1 AS/NZS 4251.1
EN55103-2 AS/NZS 4252.1
EN60950 AS/NZS60950
To ensure compliance with EMC Directive 89/336 and the Australian Radio communications Act
1992, the following conditions (outside of LSC’s control) must be met.
 The computer on which Clarity and the QX or VX peripherals are connected to must
itself be compliant to the above standards.
 High quality data cables with continuous shield must be used;
 Connectors with conductive back shells must be used.
Federal Communications Commission (FCC) Declaration of Conformity
LSC Lighting Systems (Aust) declares that the LX, QX and VX products comply with Part 15 of
the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment can radiate
radio frequency energy and, if not properly installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 reorient or relocate the receiving antenna;
 increase the separation between the equipment and receiver;
 connect the equipment into an outlet on a different circuit from that to which the
receiver is connected;
 consult your local LSC dealer or an experienced radio/television technician for help
- END -