Harken 1036 MKIII Jib Reefing & Furling - Manual (Page 9)

Parts
May 2002 Unit 3 MKIII 5
1 Bag of 26 Connector Wedges, 4 Extra Wedges
1 Prefeeder with line
1 Bag of 67 Foil Screws. Contains 7 extra screws
1 Bag of four Torque Tube Screws
1 Bag of Spare Screws. Contains one spare screw
for every application. They are not required for
installation
1 6 mm Allen Wrench
1 8 mm Allen Wrench
1 10 mm Allen Wrench
1 Locking Collar
1 Locking Split Cylinder - Used only with swage
terminals - Norseman
® , Sta-Lok ® . Rod installations
do not use this part
1 Instant Adhesive
1 Loctite ® (Blue)
1 Loctite ® (Red)
IMPORTANT
Note: Threaded headstay stud is sold separately.
Be sure that you have ordered the correct
size for your boat.
Miscellaneous Parts
Rigger Components
Furling line is not included with furling unit. Purchase
7 /
16
" (12 mm) low stretch Dacron double braid. The
length of the line should be equal to the length of the
boat plus the length of the foot of the largest genoa
plus 6' (2 m).
Foil Connector
Wedges
Prefeeder
Foil Screws
Torque Tube
Screws
Spare
Screws
Allen Wrenches
Locking
Collar
Plastic Split
Cylinder
Instant
Adhesive
Blue Loctite ®
Red Loctite ®
Top Foil
Trim Cap
Bottom
Connector
Regular Connectors
Furling Line
These parts are placed on the headstay before assembly
and may be “missing” as the parts may have been
placed on your headstay in advance.
1 Top Foil Trim Cap
1 13" (330 mm) Bottom Connector
10 10" (254 mm) Regular Connectors
If your headstay is longer than 75'7" (23.038 m)
you will need one more connector. Order part 960
for wire and -30 (11.1 mm) rod or part 997 for
-22 (9.53 mm) rod.