Comtech EF Data SDM-9000 - Manual (Page 228)

Remote Control Operation SDM-9000 Satellite Modem
B–10 Rev. 4
B.4 Status Commands/Responses
B.4.1 Configuration
Modulator
Config.
Status Command:
Response: >add/MCS_'cr'
RF_xxx'cr'
MF_nnn.nnnn'cr'
MR_nnnnn_mmmmm.mmm'cr'
AMRA_nnnnn_mmmmm.mmm'cr'
AMRB_nnnnn_mmmmm.mmm'cr'
AMRC_nnnnn_mmmmm.mmm'cr'
AMRD_nnnnn_mmmmm.mmm'cr'
MPO_snn.n'cr'
MOP_snn.n'cr'
DENC_xxx'cr'
COM_xxx'cr'
MSR_xxx'cr'
MRC_xxx'cr'
RSEN_xxx'cr''lf']
RF Output (ON/OFF)
Modulator Frequency
Modulator Rate
Preset 'A' Assignment
Preset 'B' Assignment
Preset 'C' Assignment
Preset 'D' Assignment
Modulator Power Offset
Modulator Output Power
Differential Encoder (ON/OFF)
Carrier Only Mode (ON/OFF)
Modulator Spectrum Rotation
Modulator Reference Clock
Reed-Solomon Encoder (ON/OFF)
The Modulator Configuration Status command causes a block
of data to be returned by the addressed modem. The block of
data reflects the current configuration status of the modulator
module. Additional configuration status of new options and
features will always be appended to the end.