4 utility system – Comtech EF Data SDM-9000 User Manual
Page 118

SDM-9000 Satellite Modem
Operation
Rev.4
4–45
4.2.5.4 Utility System
TIME/DATE
Displays current time and date.
To set the modem time and/or date, press [ENTER].
Press [
←
] or [
→
] to position the flashing cursor over the
parameter to be changed. Press [
↑
] or [
↓
] to change the
parameter to the desired value. Once the parameters are
displayed as desired, press [ENTER] to execute the
change.
REMOTE/BAUD RATE/PARITY
The current parity and baud rate of the modem are
displayed. The parity can be set to:
•
Even
•
Odd
•
None
The baud rate can be set from 110 to 19200 bit/s.
To set the modem baud rate and/or parity, press
[ENTER]. Press [
←
] or [
→
] to position the flashing cursor
over the parameter to be changed. Press [
↑
] or [
↓
] to
change the parameter to the desired value. Once the
parameters are displayed as desired, press [ENTER] to
execute the changes.
REMOTE ADDRESS
The current modem address is displayed (1 to 255).
To set the remote address, press [ENTER]. Press [
↑
] or
[
↓
] to change the parameter to the desired value. Press
[ENTER] to execute the change.
OPERATION MODE
Operation mode. Programs the modem operation for the
following operation:
•
Duplex
•
TX-only
•
RX-only
On entry, the flashing cursor is displayed. Press [
←
] or
[
→
] to select TX only, RX-only, or Duplex. Press [ENTER]
to execute the change.
Note: When TX-only or RX-only is selected, the
appropriate faults are masked from the Faults and Stored
Faults menu.