Comtech EF Data SDM-9000 - Manual (Page 226)

Remote Control Operation SDM-9000 Satellite Modem
B–8 Rev. 4
Interface
Substitute
Pattern
(Transmit
2047
Pattern) Command:
Response:
Status:
Response:
>add/ISP_xxx'cr''lf']
>add/ISP_xxx'cr''lf']
Where: xxx = ON or OFF.
Interface
Read Error
Select
(Receive
2047
Pattern) Command:
Response:
Status:
Response:
>add/IRE_xxx'cr''lf']
>add/IRE_xxx'cr''lf']
Where: xxx = ON or OFF.
Interface
Service
Channel
Level Command:
Response:
Status:
Response:
>add/ISCL_xxx_nnn'cr''lf']
>add/ISCL_xxx_nnn'cr''lf']
Where:
xxx = TX1, TX2, RX1, or RX2 (service channel designator).
nnn = -20 to +10, in steps of 1 (service channel level in
dBm).
Interface
Transmit
Overhead
Type Command:
Response:
Status:
Response:
>add/ITOT_xxxx'cr''lf']
>add/ITOT_xxxx'cr''lf']
Where: xxxx = NONE or IDR.
Note: If the ESC Option is not installed, only 'NONE' will be
allowed.
Interface
Receive
Overhead
Type Command:
Response:
Status:
Response:
>add/IROT_xxxx'cr''lf']
>add/IROT_xxxx'cr''lf']
Where: xxxx = NONE or IDR.
Note: If the ESC Option is not installed, only 'NONE' will be
allowed.
Transmit
Data Phase Command:
Response:
Status:
Response:
>add/TDP_xxxx'cr''lf']
>add/TDP_xxxx'cr''lf']
Where: xxxx = NRM (normal data phasing) or INV (inverted
data phasing).
Receive
Data Phase Command:
Response:
Status:
Response:
>add/RDP_xxxx'cr''lf']
>add/RDP_xxxx'cr''lf']
Where: xxxx = NRM (normal data phasing) or INV (inverted
data phasing).
IDR
Backward
Alarm
Enable Command:
Response:
Status:
Response:
>add/BW_xxx_nnn'cr''lf']
>add/BW_xxx_nnn'cr''lf']
Where:
xxx = TX1, TX2, TX3, TX4, RX1, RX2, RX3, or RX4
(backward alarm designator).
nnn = ON or OFF.
Scrambler
Type Command:
Response:
Status:
Response:
>add/SCRT_xxxx'cr''lf']
>add/SCRT_xxxx'cr''lf']
Where: xxxx = V.35, EFD, or IDR.
Descramble
r Type Command:
Response:
Status:
Response:
>add/DSCT_xxxx'cr''lf']
>add/DSCT_xxxx'cr''lf']
Where: xxxx = V.35, EFD, or IDR.