Cadac R-Type - Manual (Page 71)

Stereo Input Channel 8231 8-5
Revision R2005-2 R-Type
;14146 #+)#40FRQWURO
The ‘Q’-control varies the bandwidth of the cut/boost frequency selected as per
8.1.12. As indicated on the front panel when turned towards the low ‘Q’ symbol (‘Q’
approximately 1.0) will cause a wide bandwidth of frequencies to be affected around
the selected center frequency. When set towards the high ‘Q’ symbol (‘Q’ approxi-
mately 3.0) a narrow band of frequencies will be affected around the centre fre-
quency.
;14147 +0)#(4#%RRVW2&XW#)#)UHTXHQF\#FRQWURO#733+]#0#7.+]
This dual concentric control allows the centre frequency to be adjusted between
400Hz - 4KHz by the bottom knob and the cut and boost to be adjusted by ±18dB by
the top knob. The top knob also has a centre detent which disables this section of the
equalizer.
;14148 +0)#40FRQWURO
The ‘Q’-control varies the bandwidth of the cut/boost frequency selected as per
8.1.12. As indicated on the front panel when turned towards the low ‘Q’ symbol (‘Q’
approximately 1.0) will cause a wide bandwidth of frequencies to be affected around
the selected center frequency. When set towards the high ‘Q’ symbol (‘Q’ approxi-
mately 3.0) a narrow band of frequencies will be affected around the centre fre-
quency.
;14149 /0)#(4#%RRVW2&XW#)#)UHTXHQF\#FRQWURO#93+]#0#933+]
This dual concentric control allows the centre frequency to be adjusted between
60Hz - 600Hz by the bottom knob and the cut and boost to be adjusted by ±18dB by
the top knob. The top knob also has a centre detent which disables this section of the
equalizer.
;1414: /0)#40FRQWURO
The ‘Q’-control varies the bandwidth of the cut/boost frequency selected as per
8.1.12. As indicated on the front panel when turned towards the low ‘Q’ symbol (‘Q’
approximately 1.0) will cause a wide bandwidth of frequencies to be affected around
the selected center frequency. When set towards the high ‘Q’ symbol (‘Q’ approxi-
mately 3.0) a narrow band of frequencies will be affected around the centre fre-
quency.
;1414; /)#(4#%RRVW2&XW#)#)UHTXHQF\#FRQWURO#53+=#0#533+]
This dual concentric control allows the centre frequency to be adjusted between
60Hz - 600Hz by the bottom knob and the cut and boost to be adjusted by ±18dB by
the top knob. The top knob also has a centre detent which disables this section of the
equalizer.
;1414< /)#40FRQWURO
The ‘Q’-control varies the bandwidth of the cut/boost frequency selected as per
8.1.12. As indicated on the front panel when turned towards the low ‘Q’ symbol (‘Q’
approximately 1.0) will cause a wide bandwidth of frequencies to be affected around
the selected center frequency. When set towards the high ‘Q’ symbol (‘Q’ approxi-
mately 3.0) a narrow band of frequencies will be affected around the centre fre-
quency.