Cadac R-Type - Manual (Page 128)

GLOSSARY-X
R-Type Revision R2005-2
The control will pan the signal between A and B
group outputs as determined by “Stereo Pan to
GRPS” switch status and level setting of Aux/
Group sends, and will pan the signal between
matrices 13/14 and/or 15/16 as determined by
the “Stereo Pan to MTX” switch setting and “OP
to MTX” direct to matrix routing switches.
panning See PAN control
pan-pot See PAN control
PC Abbreviation of Personal Computer.
P-Fade Programmable fader function.
PFL Abbreviation of Pre Fader Listen.
PFL to AFL Conversion of Pre Fader Listen to After Fader
Listen.
phase-change Change of the polarity of the in-coming signal.
PNG Abbreviation of Pink Noise Generator.
Pink noise Electronically generated noise that has equal
noise power per octave. This means that the
power per Hz drops at 3dB per octave.Thus the
power spectrum is similar to live music.
post fader metering The signal level displayed on the meter indicates
the level of the signal after the fader.
POST-FADE Indicates after fader.
post-fade signal The signal that is available after the fader.
Pre/Post fader monitor Function that allows the signal to be monitored
either before or after fader.
pre-fader signal A signal that is not controlled by the fader.
Pre-INS monitor A monitoring point before the insert stage.
PSU fault indicators LEDs on the CCM that illuminates when a power
supply system is connected to the console.
PSU SYSTEM One or more power supply systems that provide
power to the console.
Q-control The Q-control varies the bandwidth of the cut/
boost frequency selected on the equalizer,
thereby narrowing or widening the frequency
band affected by the EQ-section.
QWERTY-keyboard Standard keyboard used to communicate with a
personal computer.
R to L & R The right channel is sent to both the left and
right output.
RAM Abbreviation of Random Access Memory; this
memory is located in the CCM and holds the
information contained in each of the 128 possi-
ble scene memories.
READY mode Indicates that a motorized fader is ready to send
position data to the CCM.
redundant configuration Cadac consoles are designed to allow the use