Cadac R-Type - Manual (Page 61)

Mono Input Channel 8241 7-7
Revision R2005-2 R-Type
:14157 3$1#/HIW#0#&HQWUH#0#5LJKW
When selected, this switch overrides selection of the Centre and L-R switches. This
will route the input signal to the three main LCR outputs on the LCR module (see
10
L-C-R Output 8261 ) via the pan control. The PAN control then behaves in a true LCR
fashion, panning the post-fade signal from left through centre to the right outputs.
:14158 &HQWUH#VZLWFK
Routes the post-fade signal directly to the centre output of the LCR module via the
Centre level control. If the LCR switch is activated, this switch is inactive. See
7.1.26
Centre level .
/HIW#0#5LJKW#VZLWFK
Sends the post-fade signal to the main L-R outputs on the LCR module via the PAN
control, which behaves in a normal fashion, panning the signal between left and
right. See
7.1.27 PAN Control .
:14159 &HQWUH#OHYHO
This control has 6dB in hand and is centre detented at 0dB. This control is used to
set the post-fade signal level to the centre output of the LCR module if the Centre-
switch is activated. This can be used to mix or balance signal levels when the centre
output is used as a separate mono bus in conjunction with the standard L-R bus. If
the LCR switch is activated this control is inactive.
:1415: 3$1#&RQWURO
The PAN control affects 3 different sections of the module:
For the LCR sends:
The control pans the post-fade signal from Left through Centre to Right on the LCR
module master outputs. In L-R mode, the control pans the post-fade signal from Left
through Right on the LCR module master outputs without affecting the centre sends.
For the Stereo-send:
The control pans the signal between Left and Right on the PFL/Listen module stereo
outputs.
For the matrix sends and Group sends 9 -12 & 13 - 16:
The control will pan the signal between A and B group outputs as determined by
“Stereo Pan to GRPS” switch status and level setting of Aux/Group sends, and will
pan the signal between matrices 13/14 and/or 15/16 as determined by the “Stereo
Pan to MTX” switch setting and “OP to MTX” direct to matrix routing switches.
:1415; 6WHUHR
Sends the post-fade signal via the pan control to the stereo L-R outputs located on
the PFL/Listen module. This is a separate and additional stereo bus from the main
LCR outputs located on the LCR module. The LCR-switch has no effect on the oper-
ation of this additional bus.
:1415< 6WHUHR#3$1#WR#JURXSV#<#0#45
If selected, this switch will route the auxiliary/group send from the aux/group send