2 adding channels, 1 how to add an i/p channel to a dc master, 3 how to add an i/p channel to a mute group – Cadac R-Type User Manual
Page 31: Adding channels -3, 715 $gglqj#fkdqqhov
How to use the R-Type
4-3
Revision R2005-2
R-Type
715
$GGLQJ#FKDQQHOV
71514
+RZ#WR#DGG#DQ#,23#FKDQQHO#WR#D#'�DVWHU
■
■
■
■
Press the DC button on the FCM.
■
■
■
■
Press the SET button on the FCM.
The DC and SET buttons will start to flash and the SET buttons on all channels will
illuminate.
■
■
■
■
Select DC Master by pressing the corresponding numerical button on the FCM.
■
■
■
■
On the channel you want to add, press and release the SET button immediately.
Holding the SET button for approximately 2 seconds will replace all previous assign-
ments with the current selection.
■
■
■
■
Press the SET button on the FCM to take the FCM out of assignment mode
71515
+RZ#WR#DGG#D#JURXS#RI#,23#FKDQQHOV#WR#D#'�DVWHU
■
■
■
■
Press the DC button on the FCM.
■
■
■
■
Press the SET button on the FCM.
The DC and SET buttons will start to flash and the SET buttons on all channels will
illuminate.
■
■
■
■
Select DC Master by pressing the desired numerical button on the FCM.
■
■
■
■
On the input channels you want to add, press and release the SET button imme-
diately.
Holding the SET button for approximately 2 seconds will replace all previous assign-
ments with the current selection.
■
■
■
■
Press the SET button on the FCM to take the FCM out of assignment mode
71516
+RZ#WR#DGG#DQ#,23#FKDQQHO#WR#D#087(#JURXS
■
■
■
■
Press the MG button on the FCM.
■
■
■
■
Press the SET button on the FCM.
The MG and SET buttons will start to flash and the SET buttons on all channels will
illuminate.
■
■
■
■
Select MUTE group by pressing the desired numerical button on the FCM.
■
■
■
■
On the input channel you want to add, press and release the SET button immedi-
ately.
Holding the SET button for approximately 2 seconds will replace all previous assign-
ments with the current selection.
■
■
■
■
Press the SET button on the FCM to take the FCM out of assignment mode
To mute the altered MUTE group press the corresponding numerical button on the
FCM. (Make sure the MUTE group is not in assignment mode.)
71517
+RZ#WR#DGG#D#JURXS#RI#,23#FKDQQHOV#WR#D#087(#JURXS
■
■
■
■
Press the MG button on the FCM.
■
■
■
■
Press the SET button on the FCM.
The MG and SET buttons will start to flash and the SET buttons on all channels will
illuminate.