Cadac R-Type - Manual (Page 130)

GLOSSARY-XII
R-Type Revision R2005-2
Send Bus A set of wires accessible to all sends.
SET button SET buttons are found on the FCM and the
channel faders and are used for DC Master and
Mute Group assignments.
SLEEVE The part of a 0.25” TRS jack connector which is
connected to the cable screen to provide earth
connection.
snapshot A snapshot is defined as a single memory loca-
tion within the CCM, which takes an instantane-
ous snapshot of the current console setting, i.e.
stores and can recall the following information:
Snapshot name
Currently selected DC master membership
Current DC master name if DC master are
labelled
Currently selected Mute Group membership and
Mute group status
Currently selected soft key mute and bypass
status
Current “snap-to” fader position (when motor
faders are implemented, which will be an option.
A snapshot has no dynamic contents.
SOLO See solo-in-place below.
solo-in-place Pressing the CHECK function on the
Osc&Comms module allows an operator to use
input channel MUTE buttons as a ‘solo-in-place’
for trouble-shooting.
spur A console PSU-system in a redundant config-
uration should be connected to the same phase
and circuit
(spur).
stereo group Group module configured for stereo operation.
stereo master bus Dedicated stereo mix bus.
STEREO MUTE Function on the Listen & Stereo module that
mutes the stereo output.
stereo pair Sends 1 -8 can be set to be stereo pairs; e.g.
sends 1A and 1B reproduces L & R instead of a
mono signal that is identical for A and B.
string Combination of characters constituting the
name of a memory location.
sub-group Normally receives a signal via an on/off switch
only, with no independent level control.
sub-output Level controlled output of the resulting mixed
signals of the sub-group.
summed signal One or more signals that are electronically
added together.
switch-mode power supply A power supply whose operation is based on
high-frequency switching and may or may not
include an input transformer stage. The switch-
mode power supply output voltage variations
are filtered out by an LC filter.
test signal A signal that has a known voltage or power
level.