Cadac R-Type User Manual
Page 138
INDEX-VI
R-Type
Revision R2005-2
S
SAFETY EARTH 7
Scene definition 5-1
SENDS
send the O/P from the I/P directly to the matrix 4-5
set sends 1-8 to be stereo pairs 4-4
use sends 9-16 as stereo sub-groups 4-4
Snapshot definition 5-1
Software and automation 5-1
General overview 5-1
Internal 5-1
SOLO a channel 4-6
Sound Automation Manager (SAM) 5-2
Stereo bus and its output 4-5
Stereo channel fader
Isolate 8-11
LED bargraph meter 8-10
LED indicators 8-11
MUTE 8-10
Open 8-11
SET 8-11
Stereo Channel Fader (motor fader) 8-10
Stereo Input Channel 8-1
front panel 8-2, 8-4
rear panel 8-9
Stereo input channel
-20dB Pad 8-3
48V phantom power 8-3
Centre switch 8-6
EQ PRE INS 8-6
Equalizer IN 8-6
HF EQ Boost/Cut & Frequency control 1K5Hz - 15KHz 8-4
HF Q-control 8-5
HMF Q-control 8-5
HP filter frequency control 8-6
HP Filter IN 8-6
Input Gain LEFT/RIGHT 8-2
Insert 8-8
Left - Right switch 8-6
LEFT + RIGHT 8-3
LF EQ Boost/Cut & Frequency control 20HZ - 200Hz 8-5
LF Q-control 8-5
Line-up tone 8-3
LMF Q-control 8-5
Matrix 13 - 16 8-8
MIC ON/OFF 8-2
MUTE 8-8
Output to Matrix 8-3
PAN Centre level 8-6
PAN Control 8-7
PAN Left - Centre - Right 8-6
PFL 8-8
PFL - L and R 8-3
Phase reverse 8-3
Sends 1A/B - 8A/B 8-3
Sends 9A/B - 16A/B 8-3
Stereo 8-7
Stereo PAN to groups 13-16 8-8
Stereo PAN to groups 9 - 12 8-8
Switching ON 3-14
Switch-Mode Power Supply Units 3-7
System overview and setup 2-1
System power-down procedure 3-14
System power-up procedure 3-14