Cadac R-Type - Manual (Page 107)

Listen & Stereo Output 8305 12-1
Revision R2005-2 R-Type
45 /LVWHQ#)#6WHUHR#2XWSXW#;638
The stereo output post-fader level meters show the stereo signal output level.
Pressing the MUTE switch will mute both left and right channel and switch off the
meters. Two conductive plastic faders are used to adjust the left and right output signal
levels. Monitoring the outputs can be done via the Listen module, using the Listen L
and R buttons.
The meters in the Listen section show the Listen levels pre-fader and pre-trim con-
trols. A 60mm conductive plastic fader is used to adjust the overall level of Listen L
and R outputs.
The module includes three trim controls - PFL, Listen and Ext I/P - which are used to
compensate for differences in input and output listening levels. The PFL signal
comes from the input channels and may be selected to be AFL by using a switch on
the 8285 panel beneath the Central Control Module. The LIsten signal comes from
Output, Matrix L-C-R and Stereo outputs. The Ext I/P signal comes from a pair of
XLR sockets on this modules rear panel. There are two sets of XLR outputs for Lis-
ten, designed to be connected to loudspeaker amplifiers. Pressing the Alt O/P
selects the second set of XLRs.
Switches L to L & R and R to L & R affect Headphones and Listen outputs. A DIM
switch attenuates the Listen L/S outputs 1 and 2 by approximately 20dB. A Mute but-
ton for the L/S outputs 1 and 2 is provided. The Headphones output has its own
source selection switch, level control and Mute switch.
Note that an 8359 (dummy fader module) must be mounted directly below the mod-
ule to enable control of the LED brightness level.
Following pages describes the 8305 Listen & Stereo Output module in detail.