3 line-up tone, 4 48v phantom power, 5 -20db pad – Cadac R-Type User Manual
Page 57: 6 phase reverse, 7 direct output level, 8 direct output select, 9 output to matrix, 10 sends 9a/b - 16a/b
Mono Input Channel 8241
7-3
Revision R2005-2
R-Type
selected PFLs/Listens to be cancelled, unless PFL hold has been selected or
another PFL/Listen button is still pressed. See
6.3 Fader Control Module (FCM)
1 - 4
and
through to
:1416
/LQH0XS#WRQH
Press this button to apply a Line-up tone to the input. The frequency and level of the
line up tone applied is controlled from the OSC/Comms module 8271, see
& Communications 8271 - front panel.
Pressing this button will also disable the 48v
phantom power if selected, see 6.1.4.
:1417
7;9#3KDQWRP#SRZHU
Press this button to switch on the 48V Phantom power to any connected microphone.
Notice that the 48 v phantom power is disabled on this channel if the line-up tone is
selected (see 6.1.3).
:1418
053G%#3DG
Press this button to apply -20dB attenuation to the input signal to the microphone
amplifier. If the gain potentiometer (see
) is set for 20dB and the pad
applied, this allows for the use of line level (0dB nominal) devices instead of having a
separate line input.
:1419
3KDVH#UHYHUVH
Press this button to reverse the phase of the signal coming into the module.
:141:
'LUHFW#2XWSXW#OHYHO
Use this rotary control to adjust the Direct Output level. This control has 6dB in hand
with a 0dB centre detent position.
:141;
'LUHFW#2XWSXW#6HOHFW
The direct o/p send is normally fed from post fader. Press PRE will take the signal
from pre-fader but post INS/EQ. Pressing MIC will override the PRE button (the PRE
LED will go out) taking the d/o directly from the o/p of the MIC amp. In this condition
the Highpass filter is still available if needed.
:141<
2XWSXW#WR#0DWUL[
These buttons are used to select direct routing to matrix busses 13 to 16 from POST
fader, with or without stereo panning. See
and
:14143 6HQGV#<$2%#0#49$2%
Sends 9A/B - 16A/B are dedicated mono sends, each with its own level control. Each
pair has its own PRE/POST FADER and ON/OFF switch.
Sends 9A/B - 12A/B and 13A/B - 16A/B can be selected to follow the STEREO PAN-
NING by using the buttons in the panning section at the bottom of this module. See
7.1.29 Stereo PAN to groups 9 - 12
and