Avery Dennison ALS 306 - Manual (Page 7)

8
1 P
LEASE NOTE
1.2 S
AFETY INSTRUCTIONS
ALS
306
309
GB
1.2.2 Operational safety of the unit
Proper usage
The label dispenser is a fully automatic unit for atta-
ching self-adhesive labels to products or packaging.
The company operating the unit must install it with sui-
table equipment to protect operating personnel from
danger; for example, the danger of the hands or fingers
being crushed by reaching in between the product and
the dispensing edge.
WARNING!
Improper usage of the unit can cause
accidents, property damage and production
downtime!
£ Only use the unit in accordance with the
instructions specified in this manual.
£ Do not operate the unit without the re-
quired safeguards.
£ Only configure the unit in accordance
with this manual and with the required
care.
£ Only use original accessories.
£ Do not make any modifications or altera-
tions to the unit.
£ Repairs to the device may only be per-
formed by authorised specialists who are
aware of the risks involved.
Protection against injuries by electrical
current
WARNING!
The machine operates using mains voltage!
Touching live electrical parts may expose
you to hazardous electrical currents and
may lead to burns.
£ Only operate the unit once the housing
has been reassembled properly.
£ The machine may only be connected by
authorised specialists, who are aware of
the risks involved.
£ Before cleaning, switch off the unit and
remove the power cable from the socket.
£ Only link the unit to devices that fulfil the
SELV (safety extra-low voltage) circuit re-
quirements specified in EN 60950.
£ Make sure that the power switch at the
machine is accessible.
£ In case of emergency, switch off the de-
vice.
WARNING
The unit is not protected against splashing
water in its standard model.
£ Keep the unit dry.
£ If liquids have penetrated the unit, switch
it off and disconnect or unplug the power
cable immediately. Inform a service tech-
nician.
CAUTION
A too high or low supply voltage can damage
the unit.
£ Only operate the device using the system
voltage indicated on the nameplate.
£ Ensure that the mains voltage set on the
unit is the same voltage as that provided
by the electricity supplier.