Avery Dennison ALS 306 - Manual (Page 17)

18
2 P
RODUCT DESCRIPTION
2.1 O
VERVIEW
ALS
306
309
GB
Interfaces Internal Interfaces
4) Not yet available
Status messages, test functions,
product profiles
Dimensions
5) Measurements without the dispensing edge bracket and dispensing edge
6) without unwinder
7) with unwinder on top side
Sensor interfaces for
external sensors
Label sensor:
Alternative label
sensor:
Product sensor:
APSF-sensor (Rotary
encoder):
External OD-control
sensor:
(plug in each case 4-
pin M12)
Wenglor OPT242-P800
optical, NPN, 24 V, con-
trollable sensitivity
PNP/NPN, 24 V
PNP/NPN, 24 V
single-phase/two-phase,
PNP/P-P, 24 V, max.
20 kHz
PNP, 24 V
Internal sensor inter-
faces:
Material unwinder
Pressure roller
Dancer arm
Light barrier
not used
bi-phase light barrier en-
coder
PLC interface
Outputs:
Inputs:
D-Sub15, optically insu-
lated, optionally via two
8-pin M12 (separate in-
puts/outputs in each
case)
4x PNP, 24 V, a maxi-
mum of 500 mA/channel,
total permissible output
current: 1500 mA
3x PNP/NPN, 24 V
Data interfaces:
Serial:
Ethernet:
USB:
CF card:
Control panel
interface:
RS232C (D-Sub 9),
max. 115 200 Baud
10/100 BaseT (RJ45)
Device V1.1 (USB B),
‘Full speed’ operating
mode, 12 MBit/s
Slot for 1 CompactFlash
card
RS 485 (Mini DIN 6 con-
nection) for remote con-
trol
RFID Connection for RFID
read/write unit (special
equipement)
4)
Applicator Interface Connection for Applicator
Interface (AI) board (spe-
cial equipement)
Automatic halt, if ... the label roll is spent or
no gap was found.
...the max. admissible
number of missing labels
is reached.
Test functions: Automatic diagnostics
check when switched on
Output of system data via
data interface
Status indicators: Label counter
Operating hours counter
Storage locations for
product profiles: up to 16
Width x height x depth: 5)
ALS 306
ALS 309
726 x 389 x 386 mm 6)
726 x 802 x 386 mm 7)
726 x 389 x 470 mm 6)
726 x 802 x 470 mm 7)
Weight:
ALS 306
ALS 309 54 kg
56 kg