Avery Dennison Sierra Sport2 9460 RCL Commands Programmer Manual User Manual
Page 65
Troubleshooting 5-7
756
The printer is out of supplies. Load supplies.
757
Load supplies. The calibrated supply length
differs by plus or minus .25 inches from the
format.
758
Check supply. Either the supply is not seen, or
the on-demand sensor is broken. Check for a
label jam. Clear the supply path or reload
supplies. This error may occur if you remove a
label too quickly in on-demand mode. The
printer does not recalibrate after this error.
762
Low battery. Recharge the battery.
765
Printhead failure. You need a new printhead.
768
Printhead has more than 10 bad dots or is not
connected.
If you receive error 765 or 768, you can get the printer repaired if you
have an on-site maintenance agreement. If you do not have an
agreement, return the printer to Monarch as described later in this
chapter.
790
The printer is busy. Turn off the printer. Wait
two seconds and turn it back on. Resend the
packets. If the problem continues, call
Technical Support.
791
The printer has an error pending. Turn off the
printer. Wait two seconds and turn it back on.
Resend the packets. If the problem continues,
call Technical Support.