Avery Dennison Sierra Sport2 9460 RCL Commands Programmer Manual - Manual (Page 46)

3-16 Command Reference
data_attrib The field attributes.
0 The field is a line, graphic, or a variable text or
bar code that neither increments nor
decrements.
1* The field data never changes (text).
2*# Incrementing field (text or bar code).
3* Decrementing field (text or bar code).
* These fields require you to enter something in the
fixed_data field.
# Do Not use an MSI bar code with an incrementing
text field. This combination may cause the check
digit on the MSI bar code to be incorrect.
fixed_data If the field never changes, enter up to 200 bytes of
data in this field. Or, if it is an incrementing or
decrementing field, enter the starting number in this
field. Otherwise, leave it blank (but include the split
vertical bar).
If you enter something in this field, when you print the
format with the ^P command, leave the part (for data)
corresponding to this field blank. Be sure to include
the split vertical bar to delimit the field.
Except for the single incrementing or decrementing
field per format, you cannot use this field for a bar
code.
To create a new line, use carriage return and/or line
feed.
Example
^R¦1¦R¦50¦50¦10¦35¦0¦0¦0¦10¦4¦4¦0¦0¦¦^
This command defines a field that is at point (50,50) and is 10 dots
wide and 35 dots long. This field is fixed, left justified, and not rotated.
Also, this field uses font 10 and is 4 times as wide and high than
normal.