Avery Dennison Sierra Sport2 9460 RCL Commands Programmer Manual User Manual
Page 43

Command Reference 3-13
Use the following parameters only when function is R.
w-coord
The point along the width axis where the field starts
(10 to 383). The value you enter is a measurement
(in dots) from the left side of the supply to the point
(as the feed direction points away from you).
W-coord and l-coord specify the upper-left corner of
the field.
l-coord
The point along the length axis where the field starts
(1 to 1015). The value you enter is a measurement
(in dots) from the bottom of the supply to the point
(as the feed direction points away from you).
width
The width of the field in dots (1 to 383).
The sum of w-coord and width may not exceed 383,
which is the width of the printhead.
length
The length of the field in dots (1 to 1015).
The sum of l-coord and length may not exceed
1015. If the field is a bar code, enter at least 46 for a
scannable bar code.
For the field to print, length must be at least the cell
height of the font you use. See Chapter 2, “Fields
and Formats,” for the cell heights. For a bar code,
the minimum height is 16 dots. (A dot is 1/203rd of
an inch.)
txtfld_type
Text fields only. The size type of the data for the
field. Enter 0 (fixed length field).
rotation
Text and bar code fields only. The rotation of data
within the field. Rotation occurs in a
counterclockwise direction using the lower-left corner
of the field as an anchor.
0
0-degree rotation
1
90-degree rotation