Avery Dennison Sierra Sport2 9460 RCL Commands Programmer Manual User Manual
Page 60

5-2 Troubleshooting
R e a d i n g t h e D i a g n o s t i c L a b e l
Following is the diagnostic label:
M9460 – v. 1.0
1. Mode – Indexed
2. Baud Rate - 9600
3. Comm – 8, None, 1
4. Flow Control - DTR
5. Sleep – n/a
6. Print Contrast - +35
Print Total - 00000335
Resident Font ID’s -
1,2,16
The label lists the mode, communication parameters, print contrast
setting, the number of inches printed and the fonts resident in the
printer. (Sleep mode is not applicable.)
R e s e t t i n g P r i n t e r s
Sometimes the printer receives mixed signals and loses its ability to
communicate. If this happens, reset the printer and attempt
communication again. To reset the printer, turn off the printer, wait 15
seconds, and turn it back on.
When you turn off the printer, all the information set through the online
configuration packets (A-M) is saved. See the sections in Chapter 2,
"Configuring the Printer," for more information about each packet.
I f Y o u R e c e i v e a n E r r o r M e s s a g e
Any time you receive a message that is not described in this manual,
or the recommended action does not solve the problem, call Technical
Support.