Avery Dennison Sierra Sport2 9460 RCL Commands Programmer Manual User Manual
Page 55

Response Reference 4-3
S t a t u s F l a g s
There are three status flags. Each flag is a byte long, and each bit of
the flag specifies a different error.
Status Flag 1
The following table describes the meaning of each bit in status flag 1.
Bit Description
7
0 (constant).
6
1 (constant).
5
0 (constant).
4
General Printer Status
Describes if the printer is working correctly (0) or an error
occurred (1).
3
0 (constant).
2
Supply Feed Status
Describes whether the supplies are loaded (0) or not (1).
1
Printhead Status
Describes whether the printhead is working correctly (0) or it
has bad dots or a driver problem (1).
0
Power Status
Describes whether the power is okay (0) or there is a low
battery or other power supply problem (1). A low battery
condition occurs when the battery voltage falls below 7 volts.
When this problem occurs, you can use only the ENQ
character to request the printer’s status.