Avery Dennison Sierra Sport2 9460 RCL Commands Programmer Manual User Manual
Page 42

3-12 Command Reference
D e f i n e F i e l d ( ^ R )
The Define Field command specifies information the printer must know
about a field. In defining the location of this field, determine where the
upper-left corner of the field is.
A field definition stays in the printer until you erase it with this
command. You can store a maximum of 30 field definitions in the
printer and use up to 30 fields per format. The printer discards
definitions overflowing into unavailable space.
You can use a field in multiple formats.
Syntax
^R¦identifier¦function¦w -coord¦l-coord¦width¦length¦
txtfld_type¦rotation¦justification¦field_type¦mul_1¦mul_2¦prt_attrib¦
data_attrib¦fixed_data¦^
The syntax for this command is spread over three
lines due to space limitations in this manual. In an
actual data stream, the command must fit on one
line.
identifier
The field identifier. Enter any of the following
characters: 0-9, A-Z, a-z, :, ;, <, =, >, ?, @, [, \, ], -,
and ‘. For more readable data streams, Monarch
recommends that you use only alphanumeric
characters. You cannot change this identifier after
you create the field.
To delete all fields and formats, enter $.
If you want to add a field with the same identifier as
an existing field, delete the existing field first.
function
R
Add
DR
Delete