Avery Dennison Sierra Sport2 9460 RCL Commands Programmer Manual - Manual (Page 49)

Command Reference 3-19
D e f i n e F o r m a t ( ^ T )
The Define Format command creates or deletes a format. A format
definition stays in the printer until you erase it with this command.
You can store up to 15 format definitions. The printer discards
definitions overflowing into available space.
Syntax
^T¦identifier¦function¦width¦length¦field_1¦...¦field_n¦^
identifier The format identifier. Enter any of the following
characters: 0-9, A-Z, a-z, :, ;, <, =, >, ?, @, [, \, ], -, and
‘. Monarch recommends you use only alphanumeric
characters in this field.
If you want to use the same identifier as a format already
in the printer, delete the format in the printer first.
function R Add format
DR Delete format
Use the following parameters only when function is R.
width The format width in dots (1-383). A dot is 1/203rd of an
inch.
length The format length in dots (1-1015).
field_1...
field_n
A list of up to 30 field identifiers used to print this label.
These identifiers are from the identifier field of the ^R
command. List them as they appear from top to bottom
on the format. You can list fields appearing side-by-side
in any order. If the fields are not in order, an error
occurs.
Example
^T¦1¦R¦380¦380¦1¦2¦3¦4¦7¦5¦6¦^
This command defines format 1 and stores it in RAM. The dimensions
are 380 dots wide by 380 dots high, with fields 1 through 7.