Avery Dennison Sierra Sport2 9460 RCL Commands Programmer Manual - Manual (Page 39)

Command Reference 3-9
Syntax
^l¦function¦memory¦identifer¦mem_req¦^
function A Add a graphic.
D Delete all graphics, fonts, fields, or formats.
I Take inventory.
memory If function is A, enter R (printer RAM). Otherwise, leave
this field blank (but remember to include the split vertical
bar).
identifier The graphic identifier. Enter $ to delete all graphics or
fonts. If function is I, leave this field blank (but
remember to include the split vertical bar).
mem_req If function is A, enter the amount of memory for the
graphic in bytes. Use the value listed for the file when
you use the DOS DIR command.
If the function is D, enter either A (to delete all fonts
and graphics) or G (to delete all graphics, fields, and
formats).
Example
^l¦A¦R¦H¦5734¦^
This command specifies the header information for graphic H, which is
5734 bytes long. After receiving this command, send the graphic file
to the printer.