beautypg.com

7 completing the installation, Completing the installation – Artesyn MVME4100ET Single Board Computer Installation and Use (June 2014) User Manual

Page 41

background image

Hardware Preparation and Installation

MVME4100ET Single Board Computer Installation and Use (6806800K76F)

41

3. Remove any filler panel that might fill that slot.

4. Install the top and bottom edge of the MVME4100ET into the guides of the chassis.

5. Ensure that the levers of the two injector/ejectors are in the outward position.

6. Slide the MVME4100ET into the chassis until you feel resistance.

7. Simultaneously move the injector/ejector levers in an inward direction.

8. Verify that the MVME4100ET is properly seated.

9. Secure it to the chassis using the two screws located adjacent to the

injector/ejector levers.

10.Connect the appropriate cables to the MVME4100ET.

To remove the board from the chassis, reverse the procedure and press the red locking tabs
(IEEE handles only) to extract the board.

2.7

Completing the Installation

The MVME4100ET is designed to operate as an application-specific computing blade or an
intelligent I/O board/carrier. It can be used in any slot in a VME chassis. When the MVME4100ET
is installed in a chassis, you can connect peripherals and apply power to the board.