AMETEK PLA-PLW Programming Manual - Manual (Page 73)

69
This command sets the slew time for positive going transitions. MINimum sets the slew to the fastest
possible time. MAXimum sets the slew to the slowest time.
Command Syntax SLEW
SLEW:POS
Parameters slew time, refer to model specifications | MIN | MAX
Unit ms
Query Syntax SLEW?
SLEW? MIN SLEW? MAX
SLEW:POS?
SLEW:POS? MIN SLEW:POS? MAX
Returned Parameters
SLEW:BOTH
This command sets the slew time for all programmed changes. This command programs both positive
and negative going slew time.
Command Syntax SLEW:BOTH
Parameters Refer to model specifications | MIN | MAX
Unit ms
SLEW:NEG
This command sets the slew time for negative going transitions. MINimum sets the slew to the fastest
possible time. MAXimum sets the slew to the slowest time.
Command Syntax SLEW:NEG
Parameters Refer to model specifications | MIN | MAX
Unit ms
Query Syntax SLEW:NEG?
SLEW:NEG?
MIN SLEW:NEG? MAX
Returned Parameters
TLEV
This command specifies the value for the TRANsient input.
Command Syntax TLEV
Parameters Refer individual model specification | MIN | MAX.
Query Syntax TLEV?
TLEV? MIN TLEV? MAX
Returned Parameters returns the transient level.
TRAN:TWID
This command sets the pulse width of the transients when the generator is in PULSe mode.
Command Syntax TRAN:TWID
Parameters Refer to model’s specification | MAX | MIN
Unit ms
Query Syntax TRAN:TWID?
Returned Parameters pulse width value in ms