AMETEK PLA-PLW Programming Manual - Manual (Page 50)

46
0 No error
-100 Command error[generic]
-101 Invalid character
-102
Syntax error[unrecognized command or data type]
-103 Invalid Separator
-104 Data type error[numeric or string expected]
-105 GET
not allowed
-108 Parameter not allowed[too many parameters]
-109 Missing parameter[too few parameters]
-112 Program mnemonic too long[maximum 12 characters]
-113 Undefined header[operation not allowed]
-121 Invalid character in number[include '9' in octal data, etc]
-123 Numeric overflow[exponent too large]
-124 Too
many digits[numbers too long]
-128 Numeric data not allowed
-131 Invalid suffix[unrecognized units]
-138
Suffix not allowed
-141 Invalid character data[bad character]
-148 Character data not allowed
-150 string data error
-151 Invalid string data
-158
String data not allowed
-161 Invalid block data
-168 Block
data not allowed
-200 Execution error[generic]
-220 Parameter error
-221 Parameter error[invalid channel number]
-222
Data out of range
-223 Too many data
-230 Data buffer exhausted
-241 Hardware missing[device-specific]
-310 Device dependent syntax error
-311 Addressing not allowed in a line with multiple command
-330 Self-test error
-350 Too many errors
-400 Query error[generic]
-410 Query Interrupted
-420 Query unterminated[incomplete programming message received]
-430 Query deadlocked
-440 Query unterminated[after indefinited response]
-500 command error during parallel operation
-510
try to send a command to a channel already in parallel group