beautypg.com

Source:]power:[transient:]duty, Source:]power:[transient:]frequency – AMETEK PLA-PLW Programming Manual User Manual

Page 34

background image

32

Returned Parameters

POW? and POW:TRIG? return the presently programmed
power levels. After a trigger or ABORt, POWer:TRIG? returns the same
value as POWer? .

POWer?

MAX, POWer? MIN, POWer:TRIG? MAX and POWer:TRIG?

MIN return the maximum and minimum programmable LEVel and
TLEVel values.

[SOURce:]POWer:[TRANsient:]DUTY

This command sets the duty cycle of each of the transients when the generator is in CONTinuous
mode.

Command Syntax

POWer:[TRANsient:]DUTY

Parameters

Duty cycle value. 1 – 100

Unit

Percentage (%)

Query Syntax

POWer: DUTY?

POWer: DUTY? MIN

POWer: DUTY? MAX

POWer:TRANsient:DUTY?

POWer:TRANsient:DUTY? MIN

POWer:TRANsient:DUTY? MAX

Returned Parameters

Duty cycle value in percentage.

[SOURce:]POWer:[TRANsient:]FREQuency

This command sets the frequency of the transients when the generator is in CONTinuous mode.

Command Syntax

POWer:[TRANsient:]FREQuency

Parameters

Frequency value, refer to model specifications for range | MIN | MAX

Unit

Hertz

*RST Value

1.0 Hz

Query Syntax

POWer:FREQuency?

POWer:FREQuency?

MIN

POWer:FREQuency?

MAX

POWer:TRANsient:FREQuency?

POWer:TRANsient:FREQuency? MIN

POWer:TRANsient:FREQuency? MAX

Returned Parameters

, frequency value.

[SOURce:]POWer:PROTection[:LEVel]
[SOURce:]POWer:PROTection:OVER[:LEVel]
[SOURce:]POWer:PROTection:DELay
[SOURce:]POWer:PROTection:OVER:DELay
[SOURce:]POWer:PROTection:UNDer:DELay
[SOURce:]POWer:PROTection:STATe
[SOURce:]POWer:PROTection:UNDer[:LEVel]
[SOURce:]POWer:PROTection:UNDer:STATe

Channel-Specific Power Limiting Command/Query. This command sets the over-power
protection limit or the under-power protection limit to the input power that the electronic load will sink.
When the input power reaches the over-power protection limit or falls below the under-power
protection limit for the specified delay period, the input of the electronic load is shut off and draws no
power.

The INPut:PROTection:CLEar command (or front panel key) re-enables the input power. The trigger
activated power functions (POWer[:LEV]:TRIG and POWer:TLEV) automatically keep track of