AMETEK PLA-PLW Programming Manual - Manual (Page 72)

68
S S S
I I I M M M P P P L
L L I
I I C
C C I
I I T
T T Y
Y Y
C C C
O O O M M M M M M A
A A N
N N D
D D S
S S
The section introduces some simplicity commands that depend on current operating mode.
DUTY
TRAN:DUTY
This command sets the duty cycle of each of the transients when the generator is in CONTinuous
mode.
Command Syntax DUTY
TRAN:DUTY
Parameters duty cycle value, 1 – 100.
Unit Percentage
Query Syntax DUTY?
DUTY? MIN DUTY? MAX
TRAN:DUTY?
TRAN:DUTY? MIN TRAN:DUTY? MAX
Returned Parameters an integer value representing duty cycle value
FREQ
TRAN:FREQ
This command sets the frequency of the transients when the generator is in CONTinuous mode.
Command Syntax FREQ
TRAN:FREQ
Parameters frequency value, refer to model specifications | MIN | MAX
Unit Hertz
Query Syntax FREQ?
FREQ? MIN FREQ? MAX
TRAN:FREQ?
TRAN:FREQ? MIN TRAN:FREQ? MAX
Returned Parameters
MLEV
MLEV:TRIG
This is an implied keyword that specifies the programmed level and whether that level is to be applied
immediately or on occurrence of a trigger.
Command Syntax MLEV
MLEV:TRIG
Parameters main level value, refer individual model specification | MIN |
MAX
Query Syntax MLEV?
MLEV? MIN MLEV? MAX
MLEV:TRIG?
MLEV:TRIG? MIN MLEV:TRIG? MAX
Returned Parameters main level value
SLEW[:POS]