AMETEK PLA-PLW Programming Manual - Manual (Page 49)

45
Returned Parameters integer value representing EOS code
SYSTem:CROSs:MODe:STATe
This command sets or queries the cross mode state.
Command Syntax SYSTem:CROSs:MODe:STATe
Parameters cross mode state
0 = Input Off
1 = Input Remain
Query Syntax SYSTem:CROSs:MODe:STATe?
Parameters None
Returned Parameters integer value representing cross mode state
SYSTem:CROSs:RANGe:STATe
This command sets or queries the cross range state.
Command Syntax SYSTem:CROSs:RANGe:STATe
Parameters cross range state
0 = Input Off
1 = Input Remain
Query Syntax SYSTem:CROSs:RANGe:STATe?
Parameters None
Returned Parameters integer value representing cross range state
SYSTem:EOS
This command sets or queries the value of the end-of-string(EOS) code for all interface (RS-232
interface, GPIB interface and Ethernet interface).
Command Syntax SYSTem:EOS
Parameters end-of-string(EOS) code
0 = NULL(no EOS)
1 = CR
2 = LF
3 = CR/LF
Query Syntax SYSTem:EOS?
Parameters None
Returned Parameters integer value representing EOS code
SYSTem:ERRor?
This query returns the next error message response string from the remote programming error queue.
The queue is a FIFO (first-in, first-out) buffer that stores maximum 9 errors as they occur. As it is read,
each error is removed from the queue. When all errors have been read, the query returns “0,No
error”. Please refer to the following table for detailed error code, and error message.
Query Syntax SYSTem:ERRor?
Parameters None
Returned Parameters Error code with actual error message
“SYSTem:ERRor?” returned code and error message table: