AMETEK PLA-PLW Programming Manual - Manual (Page 32)

30
P
ORT
C
OMMANDS
These commands control the general purpose digital port on the electronic load modules.
PORT
This command sets the state of the general purpose digital port on the specified electronic load
module. A value of 1 sets the state high, a 0 sets the state low.
Command Syntax PORT
Parameters 0 | 1 | OFF | ON
*RST Value OFF
Query Syntax PORT?
Returned Parameters , 0 | 1
I
NPUT
C
ONTACTOR
C
OMMANDS
These commands control the INPUT CONTACTOR function providing Mode Selection and
Delay Time Setting.
[SOURce:]INPut:CONtactor
This command configures the INPUT CONTACTOR Mode
Command Syntax INPut:CONtactor
Parameters 1: DISABLE | 2: PORT0+ @ ON | 3: PORT0+ @ ON
Query Syntax INPut:CONtactor?
Returned Parameters 1 | 2 | 3
[SOURce:]INPut:CONtactor:DELay
This command configures the INPUT CONTACTOR Mode
Command Syntax INPut:CONtactor:DELay
Parameters 50 ~ 500ms
Query Syntax INPut:CONtactor:DELay?
Returned Parameters 50 ~ 500ms