AMETEK PLA-PLW Programming Manual - Manual (Page 48)

44
S
YSTEM
C
OMMANDS
System commands control the system-level functions of the electronic load that are not
directly related to input control or measurement functions.
SYSTem:CHANnel:VERSion?
This query returns the firmware version of analog control
Query Syntax SYSTem:CHANnel:VERSion?
Parameters None
Returned Parameters MOVYYMMDD
YY = year
MM = month
DD = day
SYSTem:COMMand:SYNTax
This command sets or queries the syntax mode state
Command Syntax SYSTem:COMMand:SYNTax
Parameters Syntax Mode
0 = PEL Syntax Mode
1 = PLA/PLW Syntax Mode
Query Syntax SYSTem:COMMand:SYNTax?
Parameters None
Returned Parameters integer value representing syntax mode state
SYSTem:CONSole:BAUD
This command sets or queries the value of baud rate for RS-232 interface.
Command Syntax SYSTem:CONSole:BAUD
Parameters baud rate. 9600, 19200, 38400 and 115200 are valid baud rate.
Query Syntax SYSTem:CONSole:BAUD?
Parameters None
Returned Parameters baud rate value
Note: Default baud rate is set to 115200.
SYSTem:CONSole:EOS
This command sets or queries the value of the end-of-string (EOS) code for RS-232 interface.
Command Syntax SYSTem:CONSole:EOS
Parameters end-of-string(EOS) code
0 = NULL(no EOS)
1 = CR
2 = LF
3 = CR/LF
Query Syntax SYSTem:CONSol:EOS?
Parameters None