Dialogic 6.2 - Manual (Page 270)

General Information
November 2009 270
dptimer_
interdigit
10 ms Dial Pulse Interdigit.
Time between digits when
performing digit outpulsing.
IISDN56_DPINTERDGT_TIMER_
DEFAULT (30)
300 ms
dptimer_make 10 ms Dial Pulse Make.
Off-hook (make) time for
outdialing a dial pulse digit.
IISDN56_DPMAKE_TIMER_
DEFAULT (6)
60 ms
dptimer_post_
wink
10 ms Amount of time the protocol will
keep the line in idle state after
transmission of a wink signal
before reporting to the host the
wink has been sent. This
ensures a minimum period for
the idle signal to be present on
the line, even if the host sends
the line offhook immediately
after being notified of an
incoming call or end of a
transmitted wink.
IISDN56_DPPOSTWINK_TIMER_
DEFAULT (5)
50 ms
dptimer_pre_
wink
10 ms Dial Pulse Prewink.
Time Instant ISDN pauses
before sending a wink signal.
IISDN56_DPPREWINK_TIMER_
DEFAULT (5)
50 ms
dptimer_wink 10 ms Duration of a transmitted wink. IISDN56_DPWINK_TIMER_
DEFAULT (20)
200 ms
first_indigit_
timer
50 ms Normal First Interdigit Timer.
While racking incoming digits,
the maximum time to wait for
the first digit before giving up
and returning an incomplete
rack (valid during normal
interdigit timing only).
IISDN56_FIRST_DGT_TIMER_
DEFAULT (60)
3 seconds
fixed_pause_
timer
50 ms Fixed Pause Wait Timer.
Time to wait before allowing
outgoing dialing to commence
(applies when outgoing start dial
type is fixed pause only).
IISDN56_FIXP_TIMER_
DEFAULT (2)
100 ms
Table 13. Robbed Bit Signaling Timers (Continued)
Timer Granularity Definition Default Value